Teejet 834-P Sprayer Control Uživatelský manuál stáhnout pdf (Strana 10)

834-P Sprayer Control TECHNOLOGIES

98-70028-R0 10

Console Programming (GPT Mode)

To begin the programming process:

Be sure the Master boom switch is “OFF.”

Turn console “ON” by pressing the key. When the control console is turned on, the

software version will be displayed for approximately 5 seconds. At the same time all

LED’s will be ON.

The software version and serial number of the console will be needed when calling for

support. The serial number is located on a sticker on the back of the console.

Example: the software version is Y1.04.

After a short time the console will change to the target application rate display.

tip

select

GPA

GPT

SPEED

RPM

PSI

Inch

lbs/rot

PROGRAM MODE push 3 sec.

Y1.04

Gal/min

@40 psi

P/300

P/rot

MPH

RPM

min

tip

select

GPA

GPT

SPEED

RPM

PSI

Inch

lbs/rot

PROGRAM MODE push 3 sec.

t20.0

Gal/min

@40 psi

P/300ft

P/rot

MPH

RPM

min

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16 17 18

834-P Sprayer Control 1
Table of Contents 2
INTRODUCTION 3
SPEED/RPM DISPLAY (GPT MODE) 4
PRESSURE DISPLAY (GPT MODE) 4
SPEED/RPM DISPLAY (GPA MODE) 6
PRESSURE DISPLAY (GPA MODE) 6
Operating Instructions 7
Automatic Power Down 7
Alarms and Warnings 8
PROGRAM MODE push 3 sec 10
System Setup Mode (GPT mode) 11
SHAFT SENSOR CALIBRATION 12
SPRAY TIP CAPACITY 12
POUNDS PER ROTATION 12
System Setup Mode (GPA mode) 14
SPEED SENSOR CALIBRATION 15
Simulated Speed 16
Manual Calculation 16
SWATH WIDTH 17
2864 Old Rochester Road 18
Springfield, IL 62703 18

Komentáře k této Příručce

Žádné komentáře

Teejet 834-P Sprayer Control Uživatelský manuál Strana 10

Komentáře k této Příručce

Související produkty a manuály pro Počítače Teejet 834-P Sprayer Control