Teejet Matrix Pro 840G Assisted/Auto Steering Setup Uživatelský manuál stáhnout pdf (Strana 7)

98-05242-ENUS R4

Matrix

Pro

ASSISTED/AUTO STEERING CONFIGURATION

The Matrix Pro is used to congure the vehicle and its implements

including assisted/auto steering and tilt. For recommendations and

factory settings for the FieldPilot or UniPilot setup values, see chart on

page 19.

To access Matrix Pro AutoSteer and Tilt conguration options:

1. Press UNIT SETUP bottom tab .

2. Press CONFIGURATION side tab .

3. Select from:

►AutoSteer – used to enable/disable assisted/auto steering as

well as establish valve setup settings, steering settings and

steering angle sensor settings; and preform valve tests and

valve diagnostics.

►Tilt – used to enable/disable and calibrate the tilt function,

allowing for tilt correction for application on hilly or sloped terrain.

Figure 9: Configuration Options

Conguration

Vehicle

Implement

AutoSteer

Tilt

Lightbar

GPS

Video

Cong-> AutoSteer

Enabled

Valve Setup

Steering Settings

Valve Test

Valve Diagnostics

Angle SensorOptions

Cong-> Tilt

Field Level

Enabled

AutoSteer

When a Steering Control Module (SCM) is present, Assisted/Auto

Steering options will be available

NOTE: An update of your SCM software will also be required when

updating an existing Matrix console to Matrix Pro.

AutoSteer setup is used to Enable/Disable Assisted/Auto Steering and

congure Valve Setup, Steering Settings, Valve Test, Valve Diagnostics

and Angle Sensor. For recommendations and factory settings for the

FieldPilot or UniPilot setup values, see chart on page 19.

1. Press CONFIGURATION side tab .

2. Press AutoSteer .

3. Select if auto steering is

►On – enabled

►Off – disabled.

4. Select from:

►Valve Setup – used to congure Valve Type, Valve Frequency,

Minimum Duty Cycle Left, Minimum Duty Cycle Right and

Maximum Duty Cycle

►Steering Settings – used to establish Coarse Adjustment, Fine

Adjustment, Deadband and Lookahead

►Valve Test – used to verify if steering is directed correctly

►Valve Diagnostics – used to test the valves to see if they are

connected properly

►Options: Steering Wheel Sensor – used to select whether the

sensor is magnetic or pressure based

►Angle Sensor – used to establish the Steering Angle Sensor

(SAS) as the primary feedback sensor for auto steering,

calibrate the SAS and set an offset adjustment.

5. Press RETURN arrow or CONFIGURATION side tab to

return to the main Conguration screen.

Figure 10: AutoSteer

Conguration

Vehicle

Implement

AutoSteer

Tilt

Lightbar

GPS

Video

Cong-> AutoSteer

Enabled

Valve Setup

Steering Settings

Valve Test

Valve Diagnostics

Angle SensorOptions

1 2 3 4 5 6 7 8 9 10 11 12 ... 20 21

Komentáře k této Příručce

Žádné komentáře

Teejet Matrix Pro 840G Assisted/Auto Steering Setup Uživatelský manuál Strana 7

Komentáře k této Příručce

Související produkty a manuály pro Počítače Teejet Matrix Pro 840G Assisted/Auto Steering Setup