Teejet Legacy 6000 CAN Guide Uživatelský manuál Strana 61

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 194
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 60
Fieldware for the Legacy 6000
Software Version 2.11
Chapter 2 - Getting Started 2-31
Product Control Module (PCM) Setup
Selecting the Secondary Sensor
The Secondary sensor is used in conjunction with a Primary sensor. The Secondary Sensor types,
available in this pick list, are based on the Application type and Primary Sensor type selected (Fig-
ure 2-33). Each Secondary sensor type has a Settings Button which brings up the Sensor Settings
page. The Secondary Sensor parameters depend on the type of Primary Sensor selected (Table 2-
16).
Each PCM has six input sensors labeled A through F. Sensor inputs A - D are digital and sensor
inputs E and F are analog. The PCM CAN Bus cable harness comes with the sensor input lines
labeled A - F. The input line for a sensor can be set on the Sensor Settings page.
Figure 2-33: The Secondary Sensor Page
Primary Sensor Secondary Sensor Option
Flowmeter None
Pressure Digital Pressure Digital
Pressure Analog Pressure Analog
Granular Granular
Shaft Shaft
Injection None
Table 2-16: Secondary Sensor Options
Zobrazit stránku 60
1 2 ... 56 57 58 59 60 61 62 63 64 65 66 ... 193 194

Komentáře k této Příručce

Žádné komentáře