Teejet Legacy 6000 Manual Uživatelský manuál stáhnout pdf (Strana 27)

Chapter 2 - System Overview22

Table 2-5: Implement Setup Parameters

Setting Description

Implement Width Distance between guidelines (typically vehicle swath or spread width used for guidance

purposed. WIDTH FOR GUIDANCE ONLY!

Number of Swaths Defaults to 1. For each product applied there could be a separate swath.

Sections The number of sections that comprise a swath.

Section 1 Switch

Section 2 Switch

Section 3 Switch...

Indicates which boom switch controls section 1 of swath 1. If there are additional sections,

Implement Setup will alternate between Switch and Boom Width setup until all sections are

complete.

Boom 1 Width

Boom 2 Width

Boom 3 Width...

The width of each boom section. If there are additional booms, Implement Setup will alter-

nate between Switch and Boom Width setup until all sections are complete.

Offset Direction Y The direction (along the center line of the vehicle) from the GPS antenna to the center of the

swath (FORWARD/BACK).

Offset Distance Y Distance from the GPS antenna along the vehicle center line to the swath.

Offset Direction X The direction perpendicular (left or right) of the vehicle center line that the center of the

swath is offset.

Offset Distance X The distance from the center of the vehicle to the swath. If the Offset Direction X was set to

NONE, this screen will not appear.

Channel Assignment Allows the assignment of channel to a swath or swaths. A swath can have a single channel

or all channels assigned.

NOTE: Swath Manager automatic boom section control can only be used with

single-Swath Implement congurations. Swath Manager also dictates that

the boom-to-switch assignment in Implement Setup is 1-1, 2-2, 3-3, etc.,

in numerical order from left to right beginning with Section 1. Any other

conguration is incompatible with Swath Manager.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 158 159

Žádné komentáře

Teejet Legacy 6000 Manual Uživatelský manuál Strana 27